RTCRtpTransceiver: stop() method
The stop() method in the
RTCRtpTransceiver interface permanently stops the transceiver by
stopping both the associated RTCRtpSender and
RTCRtpReceiver.
Note: Until recently, the stopped property was provided to return true if the connection is
stopped. That property has been deprecated and will be removed at some point. Instead,
check the value of currentDirection. If it's stopped, the transceiver has been stopped.
This method does nothing if the transceiver is already stopped.
Syntax
stop()
Parameters
None.
Return value
None (undefined).
Exceptions
InvalidStateErrorDOMException-
Thrown if the
RTCPeerConnection, of which the transceiver is a member, is closed.
Usage notes
When you call stop() on a transceiver, the sender immediately stops
sending media and each of its RTP streams are closed using the RTCP
"BYE" message. The receiver then stops receiving media; the receiver's
track is stopped, and the transceiver's
direction is changed to
stopped, and renegotiation is triggered by sending a
negotiationneeded event to the RTCPeerConnection.
The negotiation process causes currentNegotiation to be set to stopped, finally indicating that the
transceiver has been fully stopped.
Note: Stopping the transceiver causes a
negotiationneeded event to be sent to the transceiver's
RTCPeerConnection, so the connection can adapt to the change.
Specifications
| Specification |
|---|
| WebRTC: Real-Time Communication in Browsers # dom-rtcrtptransceiver-stop |
Browser compatibility
BCD tables only load in the browser